Nuts, washers & other fasteners
Nuts, washers, rivets, pins, clips, and other fasteners to round out your assembly, with the same follow-up as your screws and checked under our quality controls. Send a drawing, a size, or a sample, and we'll review it before we quote.
What it is and how it works
Fasteners other than screws that usually go into the same assembly: nuts, washers, rivets, pins, clips, studs, threaded inserts, retaining rings, spacers, and anchors.
How it works
Tell us what you need with a drawing, a standard, a part number, or a sample. We review the specification, confirm availability, and send you a quote.
What sets it apart
We make our screws in our own plant. These parts come from approved suppliers, and we check them under our quality controls. You deal only with Visqué.
When it's typically considered
When your assembly uses nuts, washers, or other parts alongside your screws and you'd rather source them from the same supplier.
Substrate and application
Bolted joints with a nut, load distribution and locking with a washer, permanent joints with a rivet, and alignment or retention with pins and clips, always per your drawing or specification.
KEY POINTS TO SPECIFY
Use these references to describe your part and fill in only what you already know.
Tell us the part type and size: the nut thread (for example, 1/4-20 or M6), the washer's inside diameter, or the rivet or pin diameter and length. If it follows a standard (ASME, DIN, or ISO), include it.
What to send
Share the part number, drawing, or sample part, plus the dimensions, estimated quantity, and any known requirements. If something is still to be defined, note it in your request.
What helps us quote
Part type, size or standard, material, finish, quantity, and a sample or part number if you have one.
What each team can bring
Purchasing
Share the part number, quantity, order frequency, and whether the part goes with a screw you're also asking us to quote.
Engineering
Specify the size or standard, material, finish, and any tolerance or requirement on your drawing.
Quality
Tell us which documents you need, for example a certificate of conformance or a material cert. We confirm availability in the quote.
Key points to specify
Part type
Fill in what you already know.
You don't need to fill in everything now. Your selections carry over when you continue.
If it follows a standard (ASME, DIN, or ISO), include it. If you don't know the size, you can attach a photo or send us a sample later in your request.
Send us your requirements. We'll review them and follow up.
You can start with a drawing, a specification, a sample part, a part number, or a description.